 |
 | ||
Fabrications |
Marine |
Products |
|
Thermic Hot Water Heaters offer unlimited hot water by simply burning wood in a very efficient fire box.
One load of wood will produce sufficient hot water for an average family for two days. The water volume and insulation blanket ensure a constant ready supply of hot water. The optional internal heat exchange coil can provide a household with cost effective heating using underfloor coils or modern radiators.
Thermic hot water heaters come fitted with standard connections to allow the fitting of an electric heating element and thermostat as found in conventional electric hot water cylinders.
- Completely made from 2205 Duplex Stainless Steel which is heat resisant to 90º C.
- Fire box door is constructed from 6mm mild steel.
- Highly efficient heat exchanger coil fitted if required.
- Conical top to prevent steam pockets being trapped.
- Normally wood fired but can also use waste oil, gas or diesel.
- Excellent damping system to allow overnight heating.
- Thermostatically controlled electric element as backup.
- Steel stand can be supplied as an optional extra.
- Double Thermal Insulated - Best in the industry.
- 3 year warranty.
Contact us for queries and pricing
 | Thermic Water HeaterThis is one of the cleanest instalations we have seen to date. This set up was created to demonstrate how far you can go with a few ideas and a good design. Notice the temperature gauge for the heater above the picture, above the fire box. |
|---|
 | Thermic Water HeaterA very sharp instalation. This Thermic Heater has a solar heating coil installed, in this application using the suns heat to suppliment the hot water supply. |
|---|
 | Thermic Water HeaterThis is where we "Face up" to the heaters. This fascade is especially designed to accept wood, propane, diesel or waste oil service. All heaters can use solar and can have dedicated coils for heating or other hot water demands. |
|---|
 | Thermic Water HeaterThe Mini Booster heater is no small deal. Excellent for hot tubs or to suppliment an existing system. Nearly the entire flue is fully water jacketed to recover as much heat as is feazable. Standard overall height 2170 to top of flue.Daimeter 590. Front to back 670, flue diameter 150mm so as to connect to a standard flue kit. Heater flues are lenghtened or shortened to suit your needs. |
|---|
 | Thermic Water HeaterHow about a hot water wash up for the farm? Or a holiday camp wash up and shower system? Would a mammoth 1000 liters of hot water get the job done for you? Thermic heaters come in a wide variety of standard sizes and are be custom built to suit your every need. |
|---|
 | Thermic Water HeaterShown here a standard 600 litre unit. |
|---|
